Table of Contents
Advertisement
MTT-14B e_Manual D07-00-083P RevA00
Profile Setup
11:50:45
>LINK UP
PROFILE NAME
:
MODE
:LLC-BRG
ENCAPSULATION :AUTO
IP TYPE
:DHCP
VPI
:8
VCI
:35
DNS SERVER
:NONE
EDIT
SAVE
Figure 21 Profile Configuration Screens
IP CONFIGURATION features a PROFILE (F1) F-key that allows
for saving and retrieving complete IP configurations:
Creating and Saving a Profile
1. From the IP CONFIGURATION, select MODE and press F1.
2. In the PROFILE screen, select a blank line and press EDIT (F1) and
the last configured IP CONFIGURATION screen is displayed.
3. In either screen, when the cursor is on PROFILE NAME give
the profile a name by pressing EDIT (F1).
4. In the displayed character entry screen, press INPUT (F3) and a
cursor appears in the character grid. Use
that cursor to a desired character. When it is selected, press
ENTER and the character will appear after PROFILE NAME.
If a mistake is made, press F3 and use
incorrect character. Press one of the following:
• DELETE (F2) to delete the character.
• INSERT (F1) to insert a character.
• OVER (F1) to replace the selected character.
When finished, press F3 to exit the character grid.
5. Press F4 to save the name and return to one of the screens in
Figure 21. Configure the rest as discussed in the previous
configuration sections.
6. When finished, press F4 to save the profile.
Editing a Saved Profile
1. From the IP configuration screen, press F1.
2. In the PROFILE listing screen, select a profile and press F1.
3 In the configuration screen, make any required changes and
when finished, press F4 to save the changes.
Invoking a Profile
1. From the IP configuration screen, press F1.
2. In the PROFILE listing screen, select a profile and press F4.
3. Press F3 to connect and start the procedure.
11:50:45
<
>LINK UP
PROFILE NAME
:
MODE
:LLC-BRG
ENCAPSULATION :AUTO
IP TYPE
:STATIC
VPI
:8
VCI
:35
LOCAL IP
:0
.0
.0
GATEWAY
:0
.0
.0
DNS SERVER
:NONE
EDIT
to select the
<
.0
.0
SAVE
to move
Page 39 of 101
Advertisement
Table of Contents
