Adjusting The Intercom Volume - CyberData 011186 Operation Manual

2.3.6.2 Restoring the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note
To restore the factory default settings:
1. Press and hold the RTFM button (see SW1 in
2. The device announces that it is restoring the factory default settings.
Note

2.3.7 Adjusting the Intercom Volume

You can adjust the Intercom volume through the
Sensor Volume
Operations Guide
Each Intercom is delivered with factory set default values.
The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).
Figure 2-13. RTFM Button (SW1)
settings on the Device Configuration
931544D
Installing the SIP Outdoor Intercom
Figure 2-13) for more than five seconds.
RTFM button (SW1)
SIP Volume, Multicast Volume,
Page.
Intercom Setup
Ring Volume, and
CyberData Corporation
22