Adjusting The Intercom Volume - CyberData 011186 Operation Manual

2.3.6.2 Restoring the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note
To restore the factory default settings:
1. Press and hold the RTFM button (see SW1 in
2. The device announces that it is restoring the factory default settings.
Note

2.3.7 Adjusting the Intercom Volume

You can adjust the Intercom volume through the
Sensor Volume
Operations Guide
Each Intercom is delivered with factory set default values.
The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).
settings on the Device Configuration
930796N
Figure 2-11) for more than five seconds.
Figure 2-11. RTFM Button
SIP Volume,
Page.
Installing the VoIP Outdoor Intercom
Intercom Setup
SW1
Multicast Volume, Ring Volume, and
CyberData Corporation
17