Revision History; Revision 7.0; Revision 6.0; Revision 5.0 - Microsemi SmartFusion2 Demo Manual

Revision History

1 Revision History
The revision history describes the changes that were implemented in the document. The changes are
listed by revision, starting with the current publication.
1.1

Revision 7.0

The following is a summary of changes made in revision 7.0 of this document.
• Design Requirements,
version of Microsemi Motor Control GUI to v5.8.
• Programming files and GUI files links were edited in
v11.8 SP2 release.
1.2

Revision 6.0

The following is a summary of the changes made in revision 6.0 of this document.
• Added new section
• Updated the document for Libero v11.7 software release.
1.3

Revision 5.0

Updated the document for GUI v5.3 release (SAR 75167).
1.4

Revision 4.0

The following is a summary of the changes in revision 4.0 of this document.
• Updated the document for GUI v5.2 release (SAR 72926).
• Updated the document for Libero v11.6 software release (SAR 72926).
1.5

Revision 3.0

Added Appendix: Connecting the Motor Terminals,
1.6

Revision 2.0

Updated Table 2,
1.7

Revision 1.0

Revision 1.0 was the first publication of this document.
page 2 was edited to change the version of Libero SoC to v11.8 SP2 and the
Register Dump Feature,
page 28 and added Figure 31,
DG0598 Demo Guide Revision 7.0
Demo Design, page 2 with respect to Libero
page 24.
page 29 (SAR 69108).
page 28 to update jumper settings (SAR 66381).
1