Setting Down Loads On Shelving; Depositing A Load On The Ground - Still EXV 10 Basic Original Instructions Manual

4
Moving the load

Setting down loads on shelving

DANGER
Pay attention to the part of the forks protruding from
the load to be set down.
Do not strike the wall, the shelving or other loads
and/or objects behind the load to be picked up.
DANGER
Driving or turning with the fork carriage in the raised
position is prohibited.
This is only allowed at very slow speed when setting
down a load and/or picking one up from shelving.
– Approach the shelving at moderate speed.
Use the drive control throttles to gradually
slow down and stop the truck perpendicular
to the shelving with the tiller in the braking
position.
– Check that there is sufficient space between
the forks and the shelving.

Depositing a load on the ground

• Approach the load deposit area.
• Lower the fork arms until the load is de-
posited in the desired area and release the
fork arms from the load.
• Back up with the forklift.
DANGER
Never leave the forklift with the forks raised whether
loaded or not.
NOTE
Further information on the general rules of
forklift use is provided in the Rules for the Use
of Industrial Vehicles Manual enclosed with
this manual.
86
– Raise the forks until you reach the correct
fork insertion height.
– Move the truck slowly forwards to set down
the load.
– Lower the load until it is resting properly on
the racking.
– After setting down the load, lower the forks
without touching either the shelving or the
load.
– Put the tiller in the driving position. Look
behind to check that the way is clear. Turn
the throttle in the direction of travel towards
the operator and drive very slowly and
carefully in a straight line away from the
shelves. Brake gradually.
– Check that there is sufficient space between
the forks and the shelving.
– Lower the forks to the ground.
45728043430 EN - 05/2017
Application