Still EXV 10 Basic Original Instructions Manual page 91

Application
– Raise the forks until you reach the correct
fork insertion height.
– Move the truck slowly forwards to insert the
forks into the load.
CAUTION
Insert the fork without bumping into either the
shelving or the load.
– Insert the forks as far as possible below
the load. If possible, the forks should be
inserted far enough in that the load is resting
against the fork carriage. The load centre of
gravity must be centred between the forks.
DANGER
Pay attention to the part of the forks protruding from
the load to be lifted.
Do not strike the wall, the shelving or other loads
and/or objects behind the load to be picked up.
– Raise the load a few centimetres until it is
resting fully on the forks. If the load is stable
and secure on the forks, proceed with the
following steps. In the event of uncertainty
and/or a load that is not properly secure or
stable, lower the forks and place the load
back on the shelving.
45728043430 EN - 05/2017
4
Moving the load
83