Warning Symbols On The Equipment; Declaration Of Decontamination - Infors HT Ecotron Operating Manual

2.9 Warning Symbols on the Equipment

2.10 Declaration of Decontamination

03 May 2018
The following warning symbols (stickers) are placed on the equip-
ment:
Position
On the casing of the control rack.
Meaning
The control rack may only be opened by qualified electricians. Turn
off the equipment and pull out the power plug before commencing
any work on the electrical system.
WARNING
Over time, stickers and signs can get dirty or become illegible
for other reasons.
– Always ensure that all safety, warning and operating notes
are easy to read.
– Immediately replace any damaged signs or stickers.
When returning the equipment for repair, disassembly or disposal,
it is required for the safety of all parties involved and because of
legal provisions that a lawful declaration of decontamination is pre-
sent.
The following must be observed if this is the case:
The equipment, the component part or accessory must be en-

tirely decontaminated before sending to the manufacturer
The provider is therefore required to completely and truthfully

fill out a declaration of decontamination, and have it signed by
the person responsible.
The declaration of decontamination must be affixed on

the outer packaging in which the equipment is sent back.
These forms can be obtained from the licensed dealer or the

manufacturer. See address on page 2.
Important notice
If the return shipment is not accompanied by a signed and com-
plete declaration of decontamination or it is not affixed to the outer
packaging, the shipment will be returned unopened to the sender
at their expense (see also T&C).
Ecotron - Incubation Shaker
Safety and Responsibility
Page 19 of 90