Setting The Parameter Setpoint - Infors HT Ecotron Operating Manual

7.4.2 Setting the Parameter Setpoint

Procedure
03 May 2018
To set the setpoint for a parameter, proceed as follows:
1
1. Press the Plus or Minus button (1) to set the setpoint you
want to use for the selected parameter (rotation speed on the
left, temperature on the right).
Pressing the Plus or Minus button once increases or de-

creases the setpoint by one unit (10 min
Pressing and holding down the Plus or Minus button has

the effect that the display runs up or down through the
specified value range.
The display shows the set setpoint of the parameter. If you
make no entry for more than 2 seconds, the display alternates
between the set setpoint and the message OFF (if the param-
eter is deactivated) or the current actual value (if the parame-
ter is activated).
INFORMATION
The entered value is saved automatically. A separate confirma-
tion is not necessary. If the parameter is already activated, the
changes take effect immediately.
Ecotron - Incubation Shaker
Operation
1
/1.0 °C).
1
Page 57 of 90