Activating And Deactivating Parameters - Infors HT Ecotron Operating Manual

Ecotron - Incubation Shaker
Operation

7.4.3 Activating and Deactivating Parameters

Procedure
Page 58 of 90
Activating parameters
To activate a parameter, proceed as follows:
1
1. Press the On/Off button (1) to activate the desired parameter
(rotation speed on the left, temperature on the right).
The parameter is activated immediately. The display briefly
shows the message ON and then the current actual value of
the parameter.
When the "Rotation speed" (RPM) parameter is activated, the
shaking procedure starts up immediately. As such, we recommend
activating this parameter last. When starting up the shaker drive,
use the time until the setpoint is reached to check whether the cul-
tivation flasks are secured on the tray.
INFORMATION
The parameters need a little time to reach their set setpoints.
Until they have done so, the notice Hi or Lo is displayed, de-
pending on whether the actual value is higher or lower than the
setpoint.
Deactivating parameters
The parameters are deactivated using the On/Off button in the
same way as for activation. When a parameter is deactivated, the
view box alternates between the set setpoint and the message
OFF.
1
03 May 2018