Simatic Rf310M Mobile Reader - Siemens SIMATIC RF310M Operating Instructions Manual

Starting a system reset with battery
After inserting the batteries and switching on for the first time, the reader also carries out a
system reset if the device was previously completely discharged. If the device is not
completely discharged but you still wish to carry out a system reset, remove the battery and
briefly set the switch in the bottom right corner of the battery compartment to "OFF". This
reset is the same as a hardware reset.
Note
Data retention and data loss during system reset
When you perform a system reset, only the saved data in the flash memory are retained
("Flash Disk" directory). All other data in RAM (e.g. in the "Application Data" folder) is lost.
Note
Restoring the delivery status of the device
If you want to restore the delivery status of the device, delete the self-stored files in the
"Flash Disk" directory, especially the self-created back-up files with the ending *.pfl.
Ensure that the "Flash Disk" directory still contains the files that were supplied on delivery
(especially the files with the ending *.pfl). Otherwise, you will have to copy in the files that
were backed up on initial commissioning again.

SIMATIC RF310M Mobile Reader

Operating Instructions, 10/2013, J31069-D0191-U001-A6-7618
Advanced functions
10.4 System reset
93