Siemens SIMATIC RF310M Operating Instructions Manual page 66

RF-MANAGER RF310M software
9.3 Application mode "Mobile"
Interface structure of the data editor
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
⑪
One memory area of the most recently scanned tag is always shown in the editor. In the
drop-down list box [
you check "Complete"
otherwise you can enter values under "Address" [
relevant data area only.
66
Menu bar
Indication of the tag ID
Drop-down list box with the transponder-specific memory areas (e.g. USER) that are displayed
in the data field.
Length of the data area (the field can be edited if "Complete" is not checked)
Data field
The data can be displayed in either hexadecimal, decimal or ASCII format.
Buttons for processing the tag data:
Scan tag (ID)
•
Read tag data
•
Write to the tag
•
Indication of the tag type: RF300 or ISO
The editor window contains the tag data. The size of the represented data depends on the tag
type.
(Start) address (the field can be edited if "Complete" is not checked)
"Complete" check mark: Indication of the completely selected memory area; all memory areas
of the tag are always read or written at once, independent of the memory area currently set.
Length of the user area:
The software "RF-MANAGER" contains an additional field for the length of the user area. In this
field, you must enter the tag-specific length of the user area.
③
], you can select and display the different memory areas of the tag. If
⑩
, the current memory area will be displayed complete in the editor,
⑨
] and "Length" [⑩] to display the
Operating Instructions, 10/2013, J31069-D0191-U001-A6-7618
SIMATIC RF310M Mobile Reader