Mobile Quikstart For Portable Studies (Standby) - Siemens Acuson S1000 Instructions For Use Manual

Mobile QuikStart for Portable Studies (Standby)

The QuikStart feature for portable studies decreases the time required to power the system on
or off by using the installed battery to place the ultrasound system in a standby status.
The system can maintain the standby status for approximately four hours when the system's
power cord is not plugged into the power supply.
To place the system in a standby status:
1. Briefly press and then release the power on/off switch ( ) to power off the ultrasound
system.
Select the Standby button on the displayed System Shut Down dialog box.
2.
Note: If the system detects errors that require a system shutdown, then the Standby button is
not available. You can either select Cancel or power off the system.
If the system is transferring images, then it will wait until the transfer is complete to
power off.
Wait approximately 20 seconds after the system powers off before powering on ( ) or
unplugging the ultrasound system.
Note: Only power on the system when the power on/off switch is flashing green and when the
system is plugged into the power supply. Ensure the MAINS circuit breaker is in the on position
(I = ON).
I n s t r u c t i o n s f o r U s e
3 S y s t e m S e t u p
3 - 9