YASKAWA MP2000 Series User Manual page 86

5.2 Using the 263IF-01 as an Adaptor
5.2.2 Examples of EtherNet/IP Transmission Definition Settings
( 2 ) Connection List tab page
This section describes the settings on the Connection List tab page when performing I/O communication using the
263IF-01 as an adaptor. The settings and setting values are examples for the system configuration shown in 5.2.1 Sys-
tem Configuration Example on page 5-17.
2
The following shows the details of items.
Network Configuration Button
1
This button is valid only when online. When this button is clicked, the NetWork Configuration Search window
is displayed. You can check information on devices that have currently joined the EtherNet/IP network on this
window.
Scanner/Adaptor Selection
2
Select Adaptor.
IP Address
3
The IP address cannot be entered if Adaptor is selected.
Set the IP address of the adaptor on the Network Parameter tab page.

I/O Communication - Input Setting
D
4
Select this check box if the controller CPU will not exchange input data with the EtherNet/IP network.
 For example, when replacing the adaptor, select this check box and you can replace the adaptor without turn-
ing OFF the power supply and without any errors occurring. Clear the check box after replacing the adaptor
and that adaptor will exchange input data normally.
Instance No. [IN]
5
Set the same number as Instance No. [OUT] of the other device.
Refer to 4.2.3 ( 1 ) Details of the Connection List Tab Page on page 4-8 for more information.
Input Register
6
Set the leading address of the IW registers of the machine controller.
Set the leading address to a unique value in the range displayed at the top right of the Connection List tab page.
Size (Byte)
7
Set the same size as Output Size [Byte] of the other device. The setting range is 1 to 500 bytes.
5-18
3 4 5 6
1
7 8 9 10 11 12 13 14 15