YASKAWA MP2000 Series User Manual page 58

IP Address
3
The IP address can be entered only if Scanner is selected for
the adaptor for the 263IF-01 Module used as a scanner.
The data input range for the IP address varies in accordance with the field used as shown here.
 The IP address cannot be entered when Adaptor is selected for

I/O Communication Setting – Input Setting
D
4
Set whether the controller CPU exchanges the input data with the EtherNet/IP.
When a checkmark is entered, data exchange is not performed.
 For example, when replacing the adaptor, select this check box and you can replace the adaptor without turn-
ing OFF the power supply and without any errors occurring. Clear the check box after replacing the adaptor
and that adaptor will exchange input data normally.
Instance No. [IN]
5
Set an input instance number in the following range.
Scanner: 1 to 65534
Adaptor: 100 to 199, and 768 to 1279
 When 198 is set for the device set as Adaptor, entry in the Size field is disabled and 0 (bytes) is assigned.
 Duplication of the input instance numbers and output instance numbers is checked. When Scanner is selected,
the instance number and the size must agree with those set at the remote station. For details, refer to
4.2.3 ( 2 ) Cautions on Setting Instance No. [IN] and Instance No. [OUT] on page 4-11.
Input Register
6
Set the leading address (word) of the input area (input register IWxxxx) to be allocated to the corresponding
device as a hexadecimal number. The setting range is 0 to 7FFF.
Size (Byte)
7
Set the size of the input area (input registers IWxxxx to IWyyyy) to be allocated to the corresponding device in
bytes. The setting range is 1 to 500 bytes.

I/O Communication Setting – Output Setting
D
8
Set whether the controller CPU exchanges the output data with the EtherNet/IP.
When a check mark is entered, data exchange is not performed.
 For example, when replacing the adaptor, select this check box and you can replace the adaptor without turn-
ing OFF the power supply and without any errors occurring. Clear the check box after replacing the adaptor
and that adaptor will exchange output data normally.
Instance No. [OUT]
9
Set an output instance number in the following range.
Scanner: 1 to 65534
Adaptor: 100 to 199, and 768 to 1279
 When 198 is set for the device set as Adaptor, entry in the Size field is disabled and 0 (bytes) is assigned.
 Duplication of the input instance numbers and output instance numbers is checked. When Scanner is selected,
the instance number and the size must agree with those set at the remote station. For details, refer to
4.2.3 ( 2 ) Cautions on Setting Instance No. [IN] and Instance No. [OUT] on page 4-11.
Setting example
192. 168. 100. 200
4.2 EtherNet/IP Transmission Definition
4.2.3 Connection List Tab Page
. Enter the IP address of the other station that is
2
Field No. 4: 1 to 254
Field No. 3: 0 to 255
Field No. 2: 0 to 255
Field No. 1: 0 to 255 (excluding 127)
.
2
4-9