YASKAWA MP2000 Series User Manual page 34

3.2 Mounting and Removing a Module on the Machine Controller
3.2.1 Mounting a 263IF-01 Module
2.
Remove the Option Cover.
Hold the battery cover with the front facing forward, insert the protrusion on the battery cover into the notch at
the top of the Option Cover, and release the hook on the Option Cover.
Release the hook on the bottom in the same way and remove the Option Cover.
( 3 ) Mounting Procedures
1.
Insert the 263IF-01 Module.
Grip the top and bottom of the 263IF-01 Module, align the Module with the left side of the guide rail inside the
option slot, and push the Module straight in.
 If the Module is not inserted along the guide rail correctly, the frame ground bar on the bottom of the slot may
get damaged.
2.
Connect to the Mounting Base Connector.
After inserting the Module completely, press the Module firmly until it connects securely with the Mounting
Base connector. If the Module is connected securely, the front of the Module should approximately align with the
hooks.
3.
Mount the Option Panel.
Insert the bottom hook into the hole on the bottom of the operation panel and then securely insert the top hook
into the hole.
This completes the mounting procedure.
3-4
Guide
rail