YASKAWA MP2000 Series User Manual page 37

3.
Remove the 263IF-01 Module from the Mounting Base.
Pull the top of the option panel to remove it. A notch can be seen in the 263IF-01 Module from the gap in the
panel. Insert the round projection on the battery cover (see the following figure) into the gap in the panel so that
it engages the notch in the Module.
Hold the battery cover as shown in the following figure and rotate it toward the rear, using the round projection as
a fulcrum to disconnect the Module from the Mounting Base connector. The Module will come out toward the
front.
4.
Pull Out the 263IF-01 Module.
Hold onto the top and bottom of the Module with your fingers and pull the Module straight out. Be sure to hold
onto the edges of the Module. Do not touch the components mounted to the Module.
Place the Module that you removed into the bag that it was delivered in and store it.
 Always attach an Option Cover (JEPMC-OP2300) to any unused slot.
3.2 Mounting and Removing a Module on the Machine Controller
Notch
Fulcrum
3.2.2 Removing a 263IF-01 Module
Round
projection
3-7