( 4 ) After Mounting the Module
1.
Connect to the Hub.
Connect the 263IF-01 Module and the hub using the Ethernet cable.
Refer to 2.4.2 Cable Specifications on page 2-12 for cables that can be used.
2.
Create Module Configuration Definitions.
a) After Mounting New Modules
Execute self-configuration for each slot in which a 263IF-01 Module has been newly mounted.
Refer to 3.4 Self-configuration on page 3-15 for more information.
b) After Replacing Modules
Turn OFF the CNFG and INIT DIP switches on the Machine Controller and turn ON the power supply.
After turning ON the power, modify the module configuration as required.
Refer to 4.1.1 Displaying the Module Configuration Window on page 4-2 for information on the Module
configuration definitions.
3.2 Mounting and Removing a Module on the Machine Controller
3.2.1 Mounting a 263IF-01 Module
3-5