Attaching The Slide-Rail Assemblies To The Rack; Installing The Mounting Brackets - Oracle Exalytics In-Memory Machine Owner's Manual

mounting bracket are aligned with the five locating pins on the side of the chassis,
as shown in
Figure 3-2
With the heads of the five chassis locating pins protruding though the five keyhole
2.
openings in the mounting bracket, pull the mounting bracket toward the front of the
chassis until the mounting bracket clip locks into place with an audible click, as
shown in
Verify that the rear locating pin has engaged the mounting bracket clip.
3.
Repeat to install the remaining mounting bracket on the other side of the Oracle
4.
Exalytics In-Memory Machine.

3.6 Attaching the Slide-Rail Assemblies to the Rack

The slide rail assemblies support only racks with 9.5-mm square holes and M6 round
holes. All other racks, including those racks with 7.2-mm, M5, or 10-32 mounting
holes, are not supported. See your rack documentation for information about the size
of its rail holes.
To attach the slide-rail assemblies to the rack, complete the following steps:
(Optional) If you need to move the rack with the Oracle Exalytics In-Memory
1.
Machine installed, it is recommended that you attach the slide-rail assembly with
mounting screws and cage nuts.
Figure 3-2.
Note:
The mounting brackets are identical and can be installed on either side
of the chassis.

Installing the Mounting Brackets

Figure 3-2.
Note:
Insert the cage nuts prior to performing the next step. See the Rail
Rackmount Kit Overview and Information card for instructions on
inserting these cage nuts. This card is included with the rack kit.
Attaching the Slide-Rail Assemblies to the Rack
Chapter 3
3-4