Hpe Proliant Dl360 Gen10 Service Processor; Dl360 Port Configuration - HPE 3PAR StoreServ Software User's Manual

DL120 — Left, Port 1 (Eth0/Mgmt); Right, Port 2
(Eth1/Service)
NOTE: Port 2 on the DL120 is reserved for maintenance by Hewlett Packard Enterprise service personnel
only.
NOTE: SP rescue on DL120 is not supported using serial port option.

HPE ProLiant DL360 Gen10 Service Processor

Beginning with the SP 4.4.0 MU7 release, HPE 3PAR supports the use of the HPE ProLiant DL360
Gen10 Service Processor. This section describes conditions and features of the DL360 Gen10 Service
Processor.

DL360 port configuration

The HPE ProLiant DL360 has a separate iLO Management port on the rear side and iLO Service Port on
the front side.
Alternatively, NIC connectors 1 and 2 are the Ethernet ports and can be used as Management port and
Service port respectively .
The port configuration for the DL360 Gen10 on the rear side is as follows:
1. Slot 1 PCIe3
2. Slot 2 PCIe3
3. Slot 3 PCIe3 (optional - requires second processor)
4. Power supply 2 (PS2)
5. Power supply 1 (PS1)
6. Video port
7. NIC port 4
8. NIC port 3
DL320e — Left, Port 2 (Eth2); Right, Port 1 (Eth1)
Introduction 7