Running A Splor Or An Msplor; Running Sp Check Health - HPE 3PAR StoreServ Software User's Manual

4. Enter a new value for the parameter, then press ENTER.
5. You are prompted to enter additional parameter IDs.
6. When you are finished editing parameters, enter 0, then press ENTER.
7. When prompted, enter y, then press ENTER to save and activate your changes.
Saving and activating your changes automatically returns you to the SP Control submenu.

Running a SPLOR or an MSPLOR

To collect data to diagnose SP issues, run a Service Processor Log Out Request (SPLOR). To collect
data to diagnose SP installation issues, run a Mini Service Processor Log Out Request (MSPLOR).
To run a SPLOR using SPOCC:
Procedure
1. On the SPOCC home page, in the left navigation pane, click Support.
2. Under Service Processor, click Launch SPLOR. The SPLOR opens in a new window.
3. When the SPLOR is complete, click View SPLOR Contents.
To run a SPLOR using SPMAINT:
1. From the SPMAINT main menu, enter 1 for SP Control/Status, then press ENTER.
2. Enter 19 for Take a SPLOR, then press ENTER.
3. Once finished, press ENTER to continue.
To run an MSPLOR:
1. From the SPMAINT main menu, enter 1 for SP Control/Status, then press ENTER.
2. Enter 20 for Take an MSPLOR, then press ENTER.
3. Once finished, press ENTER to continue.

Running SP Check Health

The SP Check Health feature detects whether a storage system has duplicate IP addresses. To run the
SP Check Health feature using SPOCC:
Procedure
1. Click Support in the left navigation pane.
2. Click Health Check from the list of StoreServ actions. A pop up box appears showing progress while a
report is generated.
3. The report appears in a new browser window.
To run the SP Check Health feature using SPMAINT:
SP Control/Status Functions 25