Spmaint Overview - HPE 3PAR StoreServ Software User's Manual

Procedure
1. Log in to SPOCC.
2. In the left navigation pane, click SPmaint.
3. Under Service Processor - SP Maintenance, click SP Control/Status.
4. Under Service Processor - SP Control Menu, click SP User Access Control.
5. Under Service Processor - SP User Access Control Menu, click Change User Password.
6. In the Select User list, select the user name whose password you want to change.
7. In the New Password field, enter the new password.
NOTE:
A valid password is between 7 and 32 characters long and uses only alphanumeric characters and the
following special characters:
• Period (.)
• Forward slash (/)
• Plus sign (+)
• Equals sign (=)
• Hyphen (-)
8. In the Confirm Password field, enter the new password again.
9. Click Change Password.

SPMAINT Overview

The SPMAINT utility is an interface for the support (configuration and maintenance) of both the storage
system and its SP. Use SPMAINT as a backup method for accessing the SP; SPOCC is the preferred
access method. In this guide, the features of the SPMAINT utility are divided into the following major
categories:
• Control of the SP (for more information, see SP Control/Status Functions on page 17)
• Network configuration (for more information, see Network Configuration on page 27)
• Setup and administration of local notification (for more information, see Local Notification Service on
page 45)
• Communications with 3PAR Central or a local service provider (for more information, see HPE 3PAR
Communication Settings on page 57)
CAUTION: Many of the features and functions that are available through SPMAINT can adversely
affect a running system. To prevent potential damage to the system and irrecoverable loss of data,
do not attempt the procedures described in this manual until you have taken all necessary
safeguards.
Overview 13