Table of Contents
Advertisement
A.3 Reset Status
The reset status of a module is set when the module is
powered-on or when the module is reset by the module
watchdog. It is cleared after the responding of the first $AA5
command. This can be used to check whether the module had
been reset. When the $AA5 command responds that the reset
status is cleared, that means the module has not been reset
since the last $AA5 command was sent. When the $AA5
command responds that the reset status is set and it is not the
first time $AA5 command is sent, it means the module has
been reset and the digital output value had been changed to the
power-on value.
M-7065 User's Manual Ver2.0, Dec. /200 8 ---145
Advertisement
Table of Contents
