Ikegami HLM-960WR Operation Manual page 13

10-bit full HD LCD panel.
*HLM-2460W can accept AC power only.
(17) Downmix function
Among the embedded audio 8 channels, 5.1
channel surround audio channel (Lm, Rm, C, Ls,
and Rs) has been selected for the stereophonic
audio function at the downmix mixing ratio spec-
ified by ARIB and ISO/IEC.
You can output the downmixed audio to the
speaker that is built into the monitor or to a
headphone.
(18) 2x/4x zoom function
This function enlarges the input signal 2x and
4x without scaling, and allows you to check the
fine details of the image.
* The supported formats are 720p, 1080i, and
1080p.
(19) Image & TEST signal MIX function
While the image is displayed, a "pluge signal of
-2%/0%/+2%"can be displayed at the same time in
the corner of the screen (small enough not to dis-
turb the image) so that you can check if there is
no "black sun" effect caused by the brightness
adjustment while looking at the image.
The "brightness signal of 100 to 109%" is also
displayed at the same time so that you can check
if the signal of 100% to 109% is not saturated
when it is input during the contrast adjustment.
(20) White balance adjustment assist function
When adjusting white balance, each switch on
the front can be assigned for direct white balance
adjustment, which allows you to adjust the white
balance quickly and easily.
* Only for HLM-1760WR and HLM-2460W.
(21) UMD/IMD display with TSL protocol
This function is used to integrally control the
UMD/IMD display using "TSL UMD protocol
V3.1".
Characters (alphanumeric) and TALLY can be
displayed.
Up to 32 devices can be integrally controlled per
one line using RS485.
By increasing the number of lines, you can set
the IDs and perform individual control for up to
96 devices.
IMD In Monitor Display
UMD Under Monitor Display
HLM-960WR / 1760WR / 2460W
(22) UMD/IMD display with user display
Sets a material name (alphanumeric) with up
to 8 characters to individual monitor for each in-
put (SDI-A/SDI-B/SDI-C/SDI-D/HDMI/VBS) and
displays the preset material name with the
UMD/IMD display when the input channel is
switched.
When split screen display (Side by Side) is used,
the character display can be displayed on each
screen.
- 3 -