Ikegami HLM-960WR Operation Manual page 42

HLM-960WR / 1760WR / 2460W
* When the power is turned OFF, the captured
image will be lost. If it is desired to save it for
future use, follow item
memory, and download it from the memory when
you want to use it.
Manual switching mode between full capture
image and input signal image
This operation is possible after the full capture
mode described under item
Whenever the RE is pressed, the full capture
image and the image of the input signal will be
instantly switched over as illustrated on the dia-
gram at left, making it possible to compare the
images.
By selecting a preferred moment to change over
the switch, it is possible to ascertain the compar-
ison of color / brightness / picture quality / position,
etc. on a partial basis.
This function can be assigned to a F1 to F4 switch
on the front panel.
* The comparison of the image of the input signal
and the captured image can be performed only if
both images are in the same format. The com-
parison cannot be performed if the formats of
images of the input signal and the captured image
are different, or if the captured image has not
been stored in the memory of the monitor.
Automatic switching mode between full capture
image and input signal image
This operation is possible after the full capture
mode described under item
The full capture image and the image of the input
signal will be automatically switched over, mak-
ing it possible to compare the images.
As images are switched over automatically, it is
possible to carry out adjustments such as posi-
tioning at ease while operating the camera.
The automatic switching can be set up by frame
according to the procedure described under item
.
This function can be assigned to a function switch
on the front panel.
* The comparison of the image of the input signal
and the captured image can be performed only if
both images are in the same format. The com-
parison cannot be performed if the formats of the
input signal image and the capture image should
differ, or if the captured image has not been
stored in the memory of the monitor.
to store it in a USB
has been executed.
has been executed.
- -
32
Setting up the interval of the automatic switch-
ing mode
This operation is possible after the full capture
mode described under item
The interval of the automatic switching mode can
be specified by a unit of frame as shown below: .
1 FRAME→2 FRAMES→3 FRAMES→5 FRAMES
→10 FRAMES→30 FRAMES→60 FRAMES→
Default setting is 3 FRAMES.
has been executed.