Names Of Parts And Their Functions; Front Control Panel - Ikegami HLM-960WR Operation Manual

HLM-960WR / 1760WR / 2460W

2 Names of parts and their Functions

2-1 Front Control Panel

HLM-960WR
HLM-1760WR / 2460W
POWER switch
This switch is used to turn ON/OFF the monitor.
* This switch will not fully turn OFF the AC power
supply for the monitor.
* It takes several seconds for an image to come up
after power-on.
POWER LED
This LED is lit up in green when the power supply
for the monitor is ON.
When running on battery,
starts flickering to tell you the remaining battery
power has become low. In such case, turn off the
power and replace the battery with a new one.
When the remaining battery power gets to the
lower limit, the LED indicator starts flickering at
quicker interval for 30 sec., then the monitor will
shut down.
When using a battery, set the nominal voltage
inthe menu appropriately in accordance with the
type of battery to be used.
MENU switch
This switch is pressed to display the menu screen
and to change the menu screen.
MENU display is also possible by long press of the
rotary encoder, item
* This switch is disabled when the preset menu is
displayed.
this LED indicator
.
* The stereo speeker, which is mounted on HLM-2460W,
is not drown in the above illustration.
PRESET switch
This switch is pressed to display the preset menu.
* This switch is disabled when the menu is dis-
played.
ESC switch
This switch is pressed to escape from menu oper-
ation.
S-INPUT switch
When the input signal SDI - B / C / D is selected, the
LED will light up.
This switch is pressed to change the input signals in
the following order.
CH-A is displayed while TEST signals are displayed
(if MENU is not displayed).
SDI-A SDI-B SDI-C(only when set for input)
SDI-D(only when set for input)
SDI-A
If "○ENEBLE" is
"MENU-INPUT-SOURCE SELECT" as shown below,
only input signals set to "○ENABLE" are selected.
- 4 -
HDMI VBS
set to "×DISABLE" in