Rear Panel (Left) - Ikegami HLM-960WR Operation Manual

HLM-960WR / 1760WR / 2460W
2-2 Rear panel (left) (HLM-2460W has no DC input.)
DC input
Insert a DC cable here to supply DC +12V power.
AC power input
Insert an AC cable here to supply AC power.
Lock
After inserting an AC plug, lock the AC plug
with this lock to prevent it from disconnecting.
Fan
When power is turned on, the fan starts running
for the operational check. Then, it automatically
operates according to the internal temperature.
If the fan does not start running, the message
"FAN ERROR!" is displayed on the screen.
(for HLM-960WR)
Insert a BB-904A (ANTON BAUER battery) here
to supply battery power.
Insert a BB-904V (V type battery) here to supply
IDX battery power.
(for HLM-1760WR)
Insert a BB-1750A (ANTON BAUER battery) here
to supply battery power.
Insert a BB-1750V (V type battery) here to supply
IDX battery power.
HLM-960WR
HLM-1760WR
PRECAUTIONS
When using an external DC power supply, be sure
to check the rating of the external DC power sup-
ply, and use one that is compatible with this mon-
itor.
Check the pin arrangement of the DC output ter-
minal of the external DC power supply and the DC
IN terminal of this unit, and connect polarity
correctly.
Incorrectly connecting a + 12V power supply to the
GND terminal may cause a fire or injury.
Connect the power cord included with this unit to a
3-pin outlet with ground terminal.
- 8 -
BB-904V BB-904A
BB-1750V BB-1750A
Pin No.
1
2 3
4
Signal
GND
+12V