Table of Contents
Advertisement
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
FINAL PEDESTAL INSTALLATION
1. FOR SINGLE MOUNT PEDESTAL
a. If a single mount configuration is desired,
plug the remaining open screw holes on the
opposite side of the pedestal using
the remaining two (2) 1/4-20 x 2" Torx
T30 screw and washer sets (F) & (H),
the (2) 1/4-20 x 3/4" Torx T30 screw and
washer sets (G) & (H) and the four (4) #10
Torx T25 screw and washer sets (E) & (I) as
shown in Figure 45.
b. Verify that the black plastic caps (K) & (L)
are firmly placed in and seated against
the metal.
2. INSTALL THE TOP CAP (D)
a. Carefully fit the Cap (D) over the Top Panels
(C) of the Pedestal. The Top Panels will
slide up into the Cap so that they are fully
enclosed within the Cap. This is a tight fit.
Keep fingers clear of pinch points.
b. Push the Cap down until it is firmly seated on
top of both Top Panels and can no longer
move.
c. Verify that the Cap's four obround screw slots
are on the outside of both Top Panels and
aligned with the corresponding screw holes.
d. Secure the Cap to the Top Panels using four
(4) #10 Torx T25 screw and washer sets
(E) & (I). Do not over-tighten. See Figure 46.
3. VERIFY THE EVSE OPERATION
a. Verify the safety of the installation prior to
turning on the circuit breaker.
b. Refer to the applicable ClipperCreek EVSE
and/or TESLA
for further operational and maintenance
information.
c. OPTIONAL: After turning on power supply,
use the ClipperCreek CP-50 EVSE Tester to
confirm correct operation (applicable to
ClipperCreek EVSE only).
THE FINAL PEDESTAL INSTALLATION OF THE PROMOUNT DUO
EVSE User's Guides
®
Figure 45
Figure 46
(PMD-10) IS NOW COMPLETE.
TM
Page 36
Advertisement
Table of Contents
