ClipperCreek ProMountDuo PMD-10T Installation Manual page 33

TESLA EVSE INSTALLATION
®
3. INSTALL THE TOP ENTRY BRACKET (Q)
a. Pop out the larger Service hole knockout
b. If Load Sharing will be utilized, pop out the small
Signal hole knockout. Otherwise leave this area intact.
c. Locate two (2) of the 1/4-20, 3/4" long Torx T30 screw
and washer sets (G) & (H) (part of PMD-10 kit).
d. Install the Top Entry Bracket (Q) onto the Top Panel
(C) of the desired side of the pedestal as shown in
Figure 37.
e. Tighten both screw and washer sets securely.
f. Install the Top Entry Signal Conduit Plug (S) and push
downward until flush.
g. Install the Top Entry Power Conduit Plug (T) and push
downward until flush.
4. PREPARE THE TESLA
EVSE (P)
a. Use a T10 Torx driver to remove the screw (Z) at the
bottom of the outer cover. Carefully disengage the
snaps on the sides and top using a flathead screwdriver
and completely remove the cover. Save the screw and
cover for reassembly. See Figure 38.
b. Use a T20 security pin Torx driver to remove the six
screws (Y) on the sealing cover. See Figure 39.
Caution: Do not allow the sealing cover to hang
from the ribbon cable. Doing so can damage the
ribbon cable or its connectors. Carefully remove the
sealing cover and disconnect the ribbon cable.Save the
screws and cover for reassembly.
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
WALL CONNECTOR
®
Page 33
(continued)
ClipperCreek
, Inc.