Table of Contents
Advertisement
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
HCS EVSE INSTALLATION
1. PREPARE THE HARDWARE
a. Retrieve two (2) 1/4-20 x 2" Torx T30
screw and washer sets (F) & (H) that were
previously set aside.
b. Locate the correct HCS plastic angle
washers. These washers are included with
the HCS EVSE and do not accompany this
kit. There are two different styles of HCS
plastic angle washers. The correct style to
use with the Pedestal is the Perpendicular
Screw Mount as shown in Figure 19.
WARNING: Discard the two wood
screws used for wall mounting the
HCS EVSE (these screws accompany
the HCS packaging). DO NOT
USE WOOD SCREWS ON THIS
PEDESTAL INSTALLATION.
c. Place an HCS Perpendicular Screw Mount
plastic angle washer around the shaft of
two (2) of the 1/4-20 x 2" Torx T30 screw
and washer sets (F) & (H), just below the
metal washers. Keep these nearby for use
on upcoming steps.
2. CUT THE FLEXIBLE CONDUIT TO
LENGTH
a. Remove the packaging from the HCS
EVSE.
b. Trim the flexible Conduit to 6" as shown
in Figure 20. DO NOT CUT OR
DAMAGE THE WIRES OR WIRE
INSULATION.
c. Leave the EVSE service conductors
full length for pulling to the top of the
Pedestal.
Page 26
Advertisement
Table of Contents
