ClipperCreek ProMountDuo PMD-10T Installation Manual page 14

ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
INSTALLATION REQUIREMENTS AND CONFIGURATIONS
(continued)
CONFIGURATION F:
Required Equipment for a Single-Mount Pedestal with one
TESLA EVSE (One EVSE per Pedestal):
®
• One (1) ClipperCreek ProMountDuo™ Kit, ClipperCreek part number
0300-00-025.
• One (1) TESLA
• One (1) dedicated 208, 240 or 277V AC branch circuit.*
• One (1) circuit breaker appropriately sized for the EVSE charging capacity.*
• Two (2) Live Line conductors that are appropriately sized based on the EVSE
power requirements (5 feet of length is adequate).
• One (1) Ground Line conductor with enough length to comfortably pull all
the way through and above the top of the pedestal (5 feet is adequate).
• Conduit sized to fit all conductors.
• Four (4) Anchor Bolts with Nuts and Washers (additional washers may be
required for leveling)
CONFIGURATION G:
Required Equipment for a Dual-Mount Pedestal with two
TESLA EVSE (Two EVSE per Pedestal):
®
• One (1) ClipperCreek ProMountDuo™ Kit, ClipperCreek part number
0300-00-025.
• Two (2) TESLA
• Two (2) dedicated 208, 240 or 277V AC branch circuits.*
• Two (2) circuit breakers, appropriately sized with respect to the charging
capacity of each EVSE.*
• Two pairs (2x2) Live Line conductors (one pair for each EVSE) that are ap-
propriately sized based on the EVSE power requirements (5 feet of length is
adequate).
• Two (2) Ground Line conductors (one for each EVSE) or a single bonded
Ground Line with enough length to comfortably pull all the way through and
above the top of the pedestal (5 feet is adequate).
• Conduit sized to fit all conductors.
• Four (4) Anchor Bolts with Nuts and Washers (additional washers may be
required for leveling)
EVSE, TESLA part number 1050067-01-E.
® ®
EVSE, TESLA part number 1050067-01-E.
® ®
* Consult the TESLA Wall Connector Manual if selecting the TESLA
®
Page 14
CONFIGURATION F
Single TESLA EVSE
®
CONFIGURATION G
Dual TESLA EVSE
®
Load Sharing Option.
®