Table of Contents
Advertisement
INITIAL PEDESTAL INSTALLATION
4. INSTALL THE BOTTOM PANELS
a. Place a #10 washer (I) around the
shaft of each of the thirty-four (34)
#10 Torx T25 screws (E).
b. Place a 1/4" washer (H) around the
shaft of each of twelve (12) 1/4-20,
3/4" long Torx T30 screws (G), as
well as the four (4) 1/4-20, 2" long
Torx T30 screws (F).
c. Set aside the four (4) longer 2"
1/4-20 screw and washer sets (F) &
(H). These will be needed later.
d. Align the screw holes on the front
of the first Bottom Panel (B) with
the corresponding screw holes on
the long edge of the Pedestal Base
(A), making sure that the knockout
is on the top side.
e. Secure only the front of the first
Bottom Panel to the Base with two
(2) of the 3/4" long 1/4-20 screw and
washer sets (G) & (H) using a T30
Torx driver as shown in Figure 9.
f. Check level carefully along the
top edge of the first Bottom
Panel before installing the second
Bottom Panel. Reseat Pedestal
Base as needed, making sure the
anchor bolts are tightened as
much as possible.
g. To install the second Bottom Panel
(B), gently nest the narrow edges
of each Bottom Panel between the
Pedestal Base and the opposing
Panel.
h. Secure both Bottom Panels to
the Pedestal Base with six (6)
additional 3/4" long 1/4-20 Torx T30
screw and washer sets (G) & (H)
as shown in Figure 10.
i. Secure the middle of both Bottom
Panels with two (2) of the #10
Torx T25 screw and washer sets
(E) & (I) as shown in Figure 11.
j. Tighten securely, but do not use
such force that would cause the
Panel surface to indent.
k. Note: The Bottom Panels are
powder coated inside AND outside
for extra protection near the
concrete pad.
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
Page 21
(continued)
ClipperCreek
, Inc.
Advertisement
Table of Contents
