Table of Contents
Advertisement
LCS/ACS EVSE INSTALLATION
1. INSTALL THE LCS/ACS EVSE
b. Retrieve two (2) of the 1/4-20 x 2" Torx T30
screw and washer sets (F) & (H) that were
previously set aside.
c. Insert the screws into the upper and lower
threaded holes in the Top Panel (C) on the side
of the pedestal where the LCS/ACS EVSE will
be installed. These holes are intended for an
alternate configuration and must be plugged
prior to the LCS/ACS EVSE installation. See
Figure 26.
d. For ease of assembly, unwrap the cable and stow
the SAE-J1772™ Vehicle Connector into the
Holster as shown. The button on the Connector
does not need to be pressed, simply insert until
the audible click is heard to lock into place.
Refer to Figure 27. Coil the remaining cable on
the ground and out of the way.
e. The LCS/ACS EVSE will come with an
appropriately sized Conduit Fitting on the end of
the Flexible Conduit. Remove this fitting from
the conduit and install it onto the Top Panel at
this time, making sure the sealing washer is on
the outside of the pedestal as shown in Figure
28.
f. Carefully remove the entire length of the pre-
installed Flexible Conduit from the LCS/ACS
EVSE by loosening the domed sealing nut to
pull out the Conduit.
f. Locate one piece of the 43/8" long pre-cut LCS/
ACS Conduit (J) from the ProMountDuo™
packaging.
g. Install the 43/8" Flexible Conduit onto the
LCS/ACS EVSE. WARNING: IT IS
VERY IMPORTANT TO INSTALL THE
CONDUIT FITTING SECURELY TO
ENSURE A WATERTIGHT FIT.
See Figure 29.
h. While supporting the LCS/ACS EVSE,
carefully thread the wires into the LCS/ACS
Conduit Fitting on the Top Panel.
i. Tighten the Conduit Fitting around the Conduit.
WARNING: IT IS VERY IMPORTANT
TO TIGHTEN THE CONDUIT
FITTING SECURELY TO ENSURE A
WATERTIGHT INSTALLATION.
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
Page 29
ClipperCreek
, Inc.
Advertisement
Table of Contents
