Table of Contents
Advertisement
HCS EVSE INSTALLATION
3. INSTALL THE HCS EVSE
a. For ease of assembly, unwrap the cable and
stow the SAE-J1772™ Vehicle Connector
into the Holster as shown. The button on the
Connector does not need to be pressed, simply
insert until the audible click is heard to lock it
into place. See Figure 21. Coil the remaining
cable on the ground and out of the way.
b. While supporting the HCS EVSE horizontally,
carefully insert the wires through the HCS
Conduit fitting on the Bottom Panel (B). Insert
the wires so that they will tend to run upward
inside the pedestal for easier access at a later
step.
c. Tighten the Conduit Fitting around the
Conduit.
d. Tilt the HCS EVSE upward to the upright
mounting position. Align the two screw holes
on the top and bottom of the HCS EVSE with
the corresponding threaded inserts on the Top
Panel (C) per Figure 22.
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
(continued)
Page 27
ClipperCreek
, Inc.
Advertisement
Table of Contents
