ClipperCreek ProMountDuo PMD-10T Installation Manual page 30

Pedestal
Table of Contents

Advertisement

ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
LCS/ACS EVSE INSTALLATION
j. Align the four keyholes on the top and bottom of the
LCS/ACS EVSE with the corresponding screw holes
in the Top Panel (C). The tops of the keyholes are the
preferred locations to align with so that the washers
will grip more of the surface of the LCS/ACS EVSE
as shown.
k. Secure the top of the LCS/ACS EVSE using a T25
Torx driver and two (2) #10 Torx screw and washer
sets (E) & (I) as shown in Figure 30. Do not fully
tighten.
l. Secure the bottom of the LCS/ACS EVSE using the
remaining two (2) #10 Torx screw and washer sets
(E) & (I). Do not fully tighten.
m. Slide the keyhole slots of the LCS/ACS onto the semi-
tightened screws. Make sure the LCS/ACS is level,
then fully tighten all 4 screws. Do not over tighten.
n. Recheck and re-tighten the Conduit Fitting around the
Conduit if necessary.
o. WARNING! SILICONE MUST BE USED TO
SEAL BETWEEN THE WIRES ON THE INSIDE
OF THE LCS/ACS CONDUIT FOR ADDITIONAL
SECURITY AGAINST WATER INTRUSION AS
SHOWN IN FIGURE 31.
p. Loosely wrap the vehicle charging cable around the
body of the LCS/ACS.
3. CONNECT THE SERVICE CONDUCTOR WIRING
a. The ground conductor and ground lug connections
inside the Pedestal Post must be completed at this
time. The ground lugs have a 3/16" Hex screw (Allen
screw) and are already installed inside the Top Panels
(C) as shown in Figure 32.
NOTE: The top access hole may be blocked on
upcoming steps.
b. Connect the service conductor wiring per the LCS/
ACS User's Manual.
4. CHECK CONFIGURATIONS
a. If a Single-Mount LCS/ACS Configuration is desired,
please proceed to the Final Pedestal Installation
section.
b. If a Dual-Mount LCS/ACS EVSE Configuration
is desired, repeat the LCS/ACS EVSE Installation
section on the opposite side of the pedestal.
c. If an HCS EVSE will be placed on the opposite side,
refer to the HCS EVSE Installation section.
d. If a
TESLA
®
refer to the
TESLA
INSTALLATION OF THE LCS/ACS EVSE IS NOW COMPLETE. PLEASE REFER TO THE LCS/ACS
USER MANUAL FOR TROUBLE-SHOOTING AND ADDITIONAL INFORMATION.
will be placed on the opposite side,
EVSE
Installation section.
EVSE
®
(continued)
Page 30

Advertisement

Table of Contents
loading

Table of Contents