Table of Contents
Advertisement
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
HCS EVSE INSTALLATION
e. Use a T30 Torx driver to secure the top of the HCS EVSE using one (1) 1/4-20 x 2" Torx screw and
washer set (F) & (H) with the HCS Plastic Angle Washer as shown. Do not over-tighten. Refer to
Figure 23.
f. Secure the bottom of the HCS EVSE using one (1) 1/4-20 x 2" Torx screw and washer set (F) & (H)
with the HCS Plastic Angle Washer. Refer to Figure 24.
g. Recheck and re-tighten the Conduit Fitting around the flexible conduit to ensure a watertight
installation.
h. Loosely wrap the vehicle charging cable around the HCS.
4. CONNECT THE SERVICE CONDUCTOR WIRING
a. The ground conductor and ground lug
connections inside the Pedestal Post must
be completed at this time. The ground lugs
have a 3/16" Hex screw (Allen screw) and
are already installed inside the Top Panels
(C) as shown in Figure 25.
NOTE: The top access hole may be
blocked on upcoming steps.
b. Connect the remaining service wires per
the HCS User's Manual.
5. CHECK CONFIGURATIONS
a. If a Single-Mount HCS Configuration is desired, please proceed to the Final Pedestal Installation
section.
b. If a Dual-Mount HCS Configuration is desired, repeat the HCS EVSE Installation section on the
opposite side of the pedestal.
c. If an LCS/ACS EVSE will be placed on the opposite side, refer to the LCS/ACS EVSE Installation
section.
d. If a
TESLA
INSTALLATION OF THE HCS EVSE IS NOW COMPLETE. PLEASE REFER TO THE HCS USER
MANUAL FOR TROUBLE-SHOOTING AND ADDITIONAL INFORMATION.
will be placed on the opposite side, refer to the
EVSE
®
(continued)
Page 28
Installation section.
TESLA
EVSE
®
Advertisement
Table of Contents
