Tesla ® Evse Installation - ClipperCreek ProMountDuo PMD-10T Installation Manual

Pedestal
Table of Contents

Advertisement

TESLA
EVSE INSTALLATION
®
7. SECURE THE TESLA
ENTRY BRACKET
a. Use a T20 Torx driver with the Top and Bottom
Bracket-to-Housing Screws (W) & (X) to mount
the TESLA
EVSE as shown in Figure 42.
®
b. Push the Top and Bottom Bracket-to-Housing
screw covers (U) & (V) into place. Note that each
cover is unique and countoured to match the EVSE
curvature. Push each cover into place after
checking the contour match. Shown in Figure 42.
c. Reconnect the ribbon cable to the sealing cover,
then use a T20 security pin Torx driver to reinstall
the six sealing cover screws (Y). Ensure that
the cover is properly aligned before fully tightening
the screws. See Figure 43.
d. Screw in the Bottom Entry Conduit Plug (R) as
shown in Figure 44. NOTE: There should
not be any visible openings to the inside of the
Wall Connector, and the Wall Connector should
be completely sealed from the environment.
e. Attach the outer cover to the sealing cover starting
with the latch at the top. Engage the snaps on the
sides and align the mounting tab with the housing
at the bottom.
f. Use a T10 Torx driver to reinstall the screw (Z) that
secures the bottom of the outer cover to the TESLA
EVSE housing as shown in Figure 44.
g. Loosely wrap the cable around the TESLA
EVSE.
h. Stow the TESLA
housing bracket.
8. CHECK CONFIGURATIONS
a. If a Single-Mount TESLA
is desired, please proceed to the Final Pedestal
Installation section.
b. If a Dual-Mount TESLA
desired, repeat the TESLA® EVSE Installation
section on the opposite side of the pedestal.
c. If a HCS EVSE will be placed on the opposite
side, refer to the HCS EVSE Installation section.
d. If a LCS/ACS EVSE will be placed on the
opposite side, refer to the LCS/ACS EVSE section.
INSTALLATION OF THE TESLA
TESLA
WALL CONNECTOR EVSE INSTALLATION GUIDE FOR TROUBLE-SHOOTING AND
®
ADDITIONAL INFORMATION.
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
EVSE (P) TO THE TOP
®
connector in the TESLA
®
EVSE Configuration
®
EVSE Configuration is
®
WALL CONNECTOR EVSE IS NOW COMPLETE. PLEASE REFER TO THE
®
(continued)
Figure 42
®
®
EVSE
®
Page 35
ClipperCreek
, Inc.

Advertisement

Table of Contents
loading

Table of Contents