INITIAL PEDESTAL INSTALLATION
6. INSTALL THE TOP PANELS
a. Align the screw holes of the first Top Panel (C)
with the corresponding screw holes on the Bottom
Panel (B). The Top Panel should be overlapping
the Bottom Panel on all sides.
b. Secure only the long front edge of the first Top
Panel to the Bottom Panel with two (2) of the #10
screw and washer sets (E) & (I) using a T25 Torx
driver as shown in Figure 14. Tighten securely,
but do not use such force that would cause the
Panel surface to indent.
C. WARNING: Pull the wires over the top of
the first Top Panel so that they will be easily
accessible in later steps.
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
Page 23
(continued)
ClipperCreek
, Inc.