Table of Contents
Advertisement
TESLA
EVSE INSTALLATION
®
1. PREPARE THE TESLA
a. The TESLA
EVSE shipping box contains additional components that will be used to mount the
®
EVSE to the PMD-10 Pedestal. Refer to Figure 33.
TESLA
®
If any of the following components are damaged or missing, please contact TESLA
most recent information in the TESLA
WARNING: DO NOT USE THE TOP ENTRY BRACKET MOUNTING SCREWS IN THE TESLA
EVSE SHIPPING BOX (DO NOT USE WOOD SCREWS ON THIS PEDESTAL INSTALLATION).
USE ONLY THE 1/4-20, 3/4" LONG TORX T30 SCREW AND WASHER SETS (G) & (H).
ITEM DESCRIPTION (xQuantity):
• P.
• Q.
• R.
• S.
• T.
• U.
• V.
• W.
• X.
• Y.
• Z.
NOTE: Additional hardware is included in the PMD-10 packaging
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
EVSE AND MOUNTING COMPONENTS
®
TESLA
EVSE (aka TESLA
®
Top Entry Bracket (x1)
Bottom Entry Power Conduit Plug (x1)
Top Entry Signal Conduit Plug (x1)
Top Entry Power Conduit Plug (x1)
Top Bracket-to-Housing Screw Covers (x2)
Bottom Bracket-to-Housing Screw Covers (x2)
Bottom Bracket-to-Housing Screws (x2)
Top Bracket-to-Housing Screws (x2)
T20 Sealing Cover Screws (installed, x6)
T10 Outer Cover Screw (installed, x1)
(refer to Figure 4 on page 17 of this manual)
EVSE Manual.
®
Wall Connector)
®
Page 31
ClipperCreek
, Inc.
according to the
®
®
Advertisement
Table of Contents
