Table of Contents
Advertisement
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
TESLA
EVSE INSTALLATION
®
2. PREPARE THE SIDE OF THE PEDESTAL ON WHICH THE TESLA
MOUNTED
a. Remove the large and the small plastic caps (K) & (L) as shown in Figure 34.
b. Install the large 1.09" Service Bushing (M) in the open hole to prevent wire rubbing as shown in Figure 35.
c. Optional: If the Load Sharing option will be utilized, place the 0.50" Signal Bushing (N) in the open hole
to prevent wire rubbing per Figure 36. If Load Sharing will not be used, leave the small hole open.
d. Install the Rubber Plugs (O) into the two extruded holes by inserting the smallest end first. Pull through
the inside of the pedestal until the large end is flush with the outer surface as shown in Figure 35.
e. Retrieve two (2) of the 1/4"-20 x 2" Torx T30 screw and washer sets (F) & (H) that were previously set
aside. Insert the screws into the upper and lower threaded holes in the top panel as shown in Figure 35.
These holes are intended for an alternate configuration and must be plugged prior to the TESLA
installation.
REMOVE
BOTH CAPS
Optional: Install the small 0.50" bushing only if
utilizing the Load Sharing Option.
(continued)
Page 32
EVSE WILL BE
®
EVSE
®
Advertisement
Table of Contents
