Table of Contents
Advertisement
ProMountDuo™ PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
INITIAL PEDESTAL INSTALLATION
5. REMOVE KNOCKOUTS
CAUTION: BE CAREFUL TO CHOOSE
THE CORRECT KNOCKOUT
POSITION FOR THE PARTICULAR
CONFIGURATION PER FIGURE 12.
a. LCS/ACS Series ONLY:
• Remove the knockout under the
overhang of the Top Panel (C) on
the side to which the EVSE is to
be mounted (or both sides if Dual-
Mounting).
NOTE: In Step 6, make sure that this Top
Panel is placed on the appropriate side of
the Pedestal so that the LCS/ACS EVSE will
be facing the correct parking spot
b. HCS-Series ONLY:
• Remove the knockout on the side to
which the HCS EVSE is to be mounted
(or both sides if Dual Mounting).
• The HCS EVSE will come with an
appropriately sized Conduit fitting on
the end of the flexible conduit.
• Remove this fitting from the end of
the flexible Conduit and install it onto
the Bottom Panel hole(s) at this time,
making sure the sealing washer is on
the outside of the pedestal end of the
conduit as shown in Figure 13.
c. Optional GFCI Kit ONLY:
• Remove the knockouts on the narrow
side of the applicable Top Panel.
d. TESLA
EVSE part number 105006701-E
®
ONLY:
• This configuration does not require
knockout removal (Caps L and K are
removed in lieu of knockouts).
.
Page 22
(continued)
Optional
TESLA
®
Signal
Access
Hole & Cap
TESLA
®
Service
Access Hole
& Cap
Advertisement
Table of Contents
