Table of Contents
Advertisement
6. Choose Radio to set the domain and security ID. The values on the 5020 must
3
match the values on the access points to communicate.
Use the
(Tab) key and the cursor keys to navigate in the configuration screen.
Make the changes you need for each parameter. For help, see "Navigating in the
Configuration Application" earlier in this chapter.
7. To save your changes, press
8. If you are using UDP Plus protocol, skip the next steps and continue with the
instructions in the next section.
If you are using TCP/IP protocol, press
!
application.
'
9. Press
to highlight Exit and then press
10. Press
twice to make the changes effective.
After you have configured the 5020 for RF communications, a
remains on in the Notification Tray indicating that the 5020 is communicating with an
access point. If you do not see a
"Troubleshooting," for help.
39
jjjj
Configuring the 5020
helveticacondensed
3
to select the Apply button and then press
"
to exit the Configuration
&
.
icon or it is blinking, see Chapter 9,
3
&
.
icon appears and
3-27
Advertisement
Table of Contents
