Beep Duration - Intermec Data Collection PC User Manual

5020 Data Collection PC User's Manual

Beep Duration

Purpose: Defines the duration of the beeps on the 5020. There are two types of beeps:
•
•
Configuration: Use one of these methods:
In the Configuration or Unit Management application, choose Configure and then Unit.
Next, choose Speaker and then choose either Low Beep Duration or High Beep
Duration. For help, see Chapter 3, "Configuring the 5020."
On Cold Boot: Not saved
SNMP OID: 1.3.6.1.4.1.1963.15.3.1.4.1.2.1
1.3.6.1.4.1.1963.15.3.1.4.1.3.1
Syntax: BBdata
BCdata
You only use the two-character command BB or BC for bar code configuration labels.
Acceptable values for data are from 10 to 60,000 ms (60 seconds).
Default: 50 ms for the low beep duration
60 ms for the high beep duration
Scan: 1. Scan this bar code:
2. Scan one of these bar codes:
8-12
Nugg
Low beep
High beep
Configuration
Applications SNMP
Yes Yes
Low beep duration
High beep duration
Enter Accumulate Mode
*+/*
*+/*
Change Low Beep Duration
*$+BB*
*$+BB*
Co d e 39
Bar Codes
Yes
Low beep duration
High beep duration
Change High Beep Duration
*$+BC*
*$+BC*