Rf Domain - Intermec Data Collection PC User Manual

RF Domain

Purpose: Defines a logical partition or subnetwork of the OpenAir RF network. To establish
communications, you must assign the same domain number to every OpenAir RF
device in a wireless network. The domain number you set on the 5020 must match the
domain that is set on each access point the 5020 may communicate with. You can
continue to collect data with the 5020 as you roam in between access points as long as
all the devices have the same domain number and security ID. After you change this
parameter, suspend and resume the 5020 to make the change effective.
Configuration: Use one of these methods:
In the Configuration or Unit Management application, choose Configure and then
Network. Next, choose Radio, then Radio, and finally choose Domain. For help, see
Chapter 3, "Configuring the 5020."
On Cold Boot: Saved
SNMP OID: 1.3.6.1.4.1.1963.5.5.2.5.1.1.7.index
where index is the radio adapter card number.
Options: The domain can be any number from 0 to 15.
Default: 0
Co d e 39
Nugg
Configuration
Applications SNMP
Yes Yes
Configuration Command Reference
Bar Codes
No
8
8-61