Bowflex TreadClimber TC100 Service Manual page 93

25. With the Walking Belts properly tensioned, the Belts
may need to be adjusted to run in the center of each
Treadle.
a. Plug in the power supply.
b. Stand adjacent to the machine and run the machine at
1.5 MPH. While operating the machine, notice where the
belts run on each Treadle.
To avoid possible serious injury, do not touch
the Walking Belts.
c. The Belt Tensioning Screws are on the front end of each
Roller. If the Belt is tracking too far to the right, use a 5mm
hex wrench to turn the Right Belt Tensioning Screw clock-
wise on that Belt in a half turn increment.
d. Allow the Walking Belts to run for approximately 30
seconds noticing if the walking belt is adjusted.
e. Repeat as necessary until adjusted.
If the Belt tracks too far to the left, use a 5mm hex wrench
to turn the Left Belt Tensioning Screw clockwise on that
Belt in a half turn increment.
26. Final Inspection
Inspect your machine to ensure that all hardware is tight
and components are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct perfor-
mance in accordance with the Owner's
Manual.
93