5. Using a #2 Phillips screwdriver, remove the 2 indicated upper
screws and loosen the 2 lower indicated screws from the Rear Cover.
Lift up on the Rear Cover, releasing it from the Base Assembly and
slide it off.
6. Using a 4mm hex wrench and a 13mm (1/2") wrench, remove the 6
indicated screws from the Motor Compartment Cover.
7. Slide the Motor Compartment Cover off of the machine.
8. While holding a 13 mm (1/2") wrench on the Right Rear Roller Bolt steady, turn another 13 mm (1/2") wrench on the Drive Pulley Bolt counter-
clockwise. Remove the Drive Pulley.
Right Rear Roller Bolt
Drive Pulley Bolt
89