Bowflex TreadClimber TC100 Service Manual page 47

5. With assistance, carefully set the machine on to the right side.
Do not move the machine without aid. Injury to you or
damage to the machine can occur. The Treadles and
Walking Belts can abruptly move. To avoid possible
serious injury, keep hands away from the inside of the
Treadles and the edges of the Walking Belts.
6. Loosen the two indicated screws and remove the Left Side Cover.
7. Turn the Drive Pulley clockwise while forcing the Drive Belt to the
outside. Belt will come off of the Drive and Motor Pulley.
Keep fingers out of any pinch opportunities when turning
the Pulleys.
8. Wrap the new Drive Belt around the Motor Pulley. Start the Drive Belt on the Drive Pulley and roll it in a clockwise motion. Be sure the Belt does
not come off of the Motor Pulley.
Keep fingers out of any pinch opportunities when turning the Pulleys.
9. Roll the Drive Pulley clockwise until the Drive Belt is fully installed. Continue to roll the Belt forward while adding side pressure with fingers to align
as necessary.
10. Replace the Left Side Cover and tighten the two screws.
11. With assistance, carefully set the machine upright.
Do not move the machine without aid. Injury to you or damage to the machine can occur. The Treadles and Walking Belts can
abruptly move. To avoid possible serious injury, keep hands away from the inside of the Treadles and the edges of the Walking
Belts.
12. Replace the Rear Step and secure with screws.
13. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's
Manual.
47
Left Side Cover