Bowflex TreadClimber TC100 Service Manual page 73

11. Remove the lower mounting bolt from the Cylinders. Leave the tops
attached.
12. Disconnect the Cylinders from the Treadles, and lower each Treadle
gently.
The Treadle will fall abruptly if not supported. Keep hands
away from the inside of the Treadles to avoid possible
serious injury.
13. Using a #2 Phillips screwdriver, remove the two screws (indicated by
ovals) that secure the Motor Control Board (MCB).
14. Adjust the MCB to allow more access under the Treadle Assembly. Be
sure not to crimp or damage any of the cables.
15. Using a 13mm (1/2") wrench, remove the 8 indicated bolts from both
sides of the Treadle Assembly.
16. Carefully lift the Treadle Assembly off of the machine.
Note: THIS STEP REQUIRES TWO PEOPLE.
Do not move the machine without aid. Injury to you or
damage to the machine can occur. The Treadles and Walking
Belts can abruptly move. To avoid possible serious injury,
keep hands away from the inside of the Treadles and the
edges of the Walking Belts.
The Treadle will fall abruptly if not supported. Keep hands
away from the inside of the Treadles to avoid possible
serious injury.
The Walking Belts can abruptly move. To avoid possible
serious injury, keep hands away from the edges of the
Walking Belts.
Motor Control Board
Drive Pulley Bolt
Drive Pulley
73
Right Rear Roller Bolt
Side Bearing Plates