Bowflex TreadClimber TC100 Service Manual page 91

13. Using a 11mm wrench, remove the 4 indicated bolts holding the
Treadle Stop to the Right Treadle. There are two bolts on each side of
the Treadle.
14. Remove the Treadle Stop.
15. Using two 13mm wrenches, remove the two bolts from the Roller
Bearing Plate.
Note: One wrench is required to hold the nut under the Treadle (not
shown) in place, and the other for the indicated bolt.
16. Remove the Front Roller by sliding it out of the belt.
17. With assistance, carefully set the machine on to the left side.
Do not move the machine without aid. Injury to you or
damage to the machine can occur. The Treadles and
Walking Belts can abruptly move. To avoid possible
serious injury, keep hands away from the inside of the
Treadles and the edges of the Walking Belts.
18. Using a #2 Phillips screwdriver, loosen the two indicated screws and
remove the Right Rear Cover.
19. With assistance, carefully place the machine back on the ground in
the normal orientation.
Do not move the machine without aid. Injury to you or
damage to the machine can occur. The Treadles and
Walking Belts can abruptly move. To avoid possible
serious injury, keep hands away from the inside of the
Treadles and the edges of the Walking Belts.
91
Roller Bearing
Treadle Stop
Plate