Bowflex TreadClimber TC100 Service Manual page 38

To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the
!
wall outlet and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power
cord in a secure location.
1. Unplug the power cord from the machine and wait 5 minutes.
2. Using a 5mm hex wrench, remove the six screws in the indicated areas
(three screws visible in image) that secure the Console/Handlebar As-
sembly.
3. Slightly remove the Console/Handlebar Assembly from the Right
Upright and disconnect the Upper and Lower I/O Cables. When discon-
nected, fully remove the Console/Handlebar Assembly while not allowing
the lower I/O Cable to fall into the Right Upright. Tie the I/OCable off with
some wire or string to be sure it does not fall into the Upright.
This step may require two people.
Note: Do not crimp the cables.
Note: Images displayed may be different from current configuration.
4. Place the Console/Handlebar Assembly face down onto something that
will protect it from marking or damage, such as a blanket.
5. Using a 5mm hex wrench, remove the four indicated screws that secure
the Console Main Body.
38