Bowflex TreadClimber TC100 Service Manual page 50

7. Using two 13mm wrenches, remove the two indicated bolts from the
Roller Bearing Plate.
Note: One wrench is required to hold the nut under the Treadle (not
shown) in place, and the other for the indicated bolt.
8. Remove the Front Roller by sliding it out of the belt.
9. Installation is the reverse procedure.
Note: Be sure to tighten the Belt Tensioning Screws the number of turns
previously recorded.
10. With the Belt Tensioning Screws and Brackets replaced, check the
walking belt tension. To check, pull the belt upward at it's midpoint and
measure the distance to the deck.
If the distance is more than an inch, the belt is loose. To tighten, turn both
bolts clockwise one-half a turn and check tension again. Repeat this step
if necessary. Be sure not to over-tighten the belts.
11. Plug in the fitness machine into an appropriately rated outlet.
Note: The TC100 TreadClimber
directly into a properly wired and grounded three prong 120V outlet. If you
connect the machine to an outlet with GFI (ground fault interrupt) or AFI
(arc fault interrupt), machine operation can cause the circuit to trip.
12. Standing adjacent to the machine, turn on the belts and run at 1.5 mph
for about a minute.
13. Inspect the alignment of the Walking Belts. If the belt is tracking too far
on a side, turn the Belt Tensioning Screw on that side a full turn. If neces-
sary, continue to adjust the Belt Tensioning Screw until aligned.
14. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
fitness machine is designed to plug
®
Roller Bearing Plate
50